Program upload

Submit documents for one program at a time. Please upload a large image and not a small thumbnail image. Dark, blurry or unreadable information will cause delays in processing.

The personal information you provide on this form is collected by BC Housing under section 26 c of the Freedom of Information and Protection of Privacy Act, for the purpose of matching uploaded documents to existing applications with BC Housing, or to track and process newly submitted applications for programs administered by BC Housing.

Sign In. Episode guide. Play trailer Comedy Mystery Sci-Fi. Creator Greg Daniels. Top credits Creator Greg Daniels. See more at IMDbPro. Episodes Browse episodes. Top Top-rated. Clip Trailer Coming to Prime Video May 1. Interview Upload Into? Video Upload S1 - Welcome Post - 30 spot.

Upload - Trailer Post. Photos Top cast Edit. Zainab Johnson Aleesha as Aleesha. Kevin Bigley Luke as Luke. Yes, put the jumper in 5V. In our case, it worked in both configurations. However, many of our readers had problems with the 3. Eduardo you are correct, the jumper should be set to 3. The [ESP32 chip] only runs at 3. If you do, current will flow through the built-in protection diodes into the 3. The FTDI jumper must be set to 3.

BUT with this 3. The [ESP32 board] takes the 5V input and regulates it down to 3. So the red wire in the hook-up diagram is incorrect. On my FTDI board this pad is located 4 holes up from the end on the long edge of the board. Hey, thank you for the great tutorial, it runs perfectly with the programmer hooked on it, but can it be run without the FTDI once it was programmed?

I am not getting it to work the moment I run it without the interface. Any suggetions? We used a 5V power adapter as shown in this image and it worked fine: randomnerdtutorials. Not making any sense to me. I have no idea. It works fine for me, whether it is connected to a PC or a power bank. He is correct on all accounts. We are designing after market products using this board. I am confident in saying that there is an error in this board. I will look at the circuit diagram but I am not going expend much time doing so.

Hi Rex. Can I assume that board is faulty? If possible could you please let me if there is any way to test at least if board is working. That board, looking at the photo seems OK. In this article we already discuss the main issues and possible ways to solve them.

Maybe you can check your FTDI programmer? Are you sure it works OK? What FTDI programmer are you using? Mine is a Chinese brand so I was not expecting it will work properly. I encountered the expected errors and bugs so to speak. Is this expected? In that way logic levels will be at 3. I have seen other hookups leaving the jumper at the 3. Either hookup may work but not reliably and the 5v jumper position could very well damage your ESPCam. I am so grateful for this forum.

Only after I switched to 5 V mode from 3. I do have a problem however—there are a lot of fine horizontal lines in the picture—is there any way to prevent this? OR is this part of the normal diy experience??? The horizontal lines are not normal. It may be a weak wi-fi signal or the camera might be not connected properly.