2009 scion xb repair manual

Remove the 4 bolts. Remove the bolt and cord clip. Using SST, remove the coil. SST , , , , , , Remove the washer. Remove the generator rotor. Remove the 4 screws and bearing retainer. Using SST and a hammer, tap out the bearing. SST , Hold the center of the pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise. If the result is not as specified, replace the generator clutch pulley. Using vernier calipers, measure the brush length.

Standard length: 9. Minimum length: 4. If the brush length is less than the minimum, replace the generator brush holder assembly. Check the appearance. Check that the bearing is not rough or worn.

OK: The bearing rotates smoothly. If the result is not as specified, replace the generator rotor assembly. Check the resistance. Measure the resistance between the slip rings. Measure the resistance between the slip ring and rotor core. Check the slip ring diameter. Using vernier calipers, measure the slip ring diameter. Standard diameter: Minimum diameter: 14 mm 0. If the diameter is less than the minimum, replace the generator rotor assembly. If the bearing does not rotate smoothly, replace the bearing.

Using SST and a press, press in a new generator drive end frame bearing. Fit the tabs on the retainer plate into the cutouts on the drive end frame to install the retainer plate. Install the 4 screws. Torque: 2. Diagnostic Procedures. Wiring Diagrams. Here is what you'll get. Step-by-step factory recommended repair instructions. Unlimited access to personal support reps who are always available to assist you.

We can answer your questions about using the software or help you find the specific information you need for your Scion xB. Free real-time updates! Your manual is updated with revised information as soon as it is released. HINT: If the battery is not fully charged, the ammeter reading may be more than the standard current. Check the reading on the ammeter. Standard current: 30 A or more If the ammeter reading is less than the standard current, replace the generator assembly.

HINT: If the battery is fully charged, the ammeter reading may be less than the standard current. In this case, increase electrical load by operating devices such as the wiper motor and rear window defogger. Then, recheck the reading on the ammeter. Disconnect the generator connector. Remove the nut and disconnect the wire harness from terminal B. Separate the 2 wire harness clamps. Remove the 2 bolts and generator assembly.

Remove the bolt and remove the wire harness clamp bracket. Using a screwdriver, puncture the center of the generator pulley cap and pry it off. SST c. Clamp SST A in a vise. Place the rotor shaft end into SST A. All rights reserved. All information contained herein applies to vehicles registered in the 48 U. App Store is a service mark of Apple Inc. Manage Your Profile Sign Out. Select A Vehicle.