Install tapco intrafuse sks stock

I mostly shoot them and clean them. The directions were excellent, and the photos helped. The product was great; no adjustments or cutting or filling was needed. I also bought one of the 20 round mags The only modifications I made where on the underside of the foregrip, I have a Russian made SKS with the collapsible bayonet I could have chosen to remove the bayonet and make no adjustments at all.

With my limited background, I assumed it would be an all-day project If more bullets had been available, I would have given them. Oh, I don't think the price is terrible either Thanks, Tapco. Norinco SKS, the stock essential, just clicked in as if it was a custom fit. I highly recommend ATI Outdoors.

The final result has had added a modified UTG rail that I tapped into the receiver to double ensure no wandering of sight during fire. Just a beautiful result. See Details. One Time Offers have limited quantities available and usually once they are sold out, they are not offered again.

When will it arrive? Zip Code: Update Delivery Dates. Made in USA. Compatible With: SKS. They are printed on the back of the package. Like the typical man I passed them by. Once the new furniture was installed I tried it on to see how it fit from multiple carry positions and butt stock settings. I found the two lowest setting of the butt stock most comfortable. The next day I went to pull the trigger and throw some lead down range and see how the Intrafuse stood up to use on the firing line.

There was an unmistakable difference in how the SKS handled. Even without the vertical grip installed it was much more comfortable to shoot. With the vertical grip installed it shot like a precision tactical weapon.

It was much easier to get the SKS in position and on target. After several rounds I could no longer resist the rapid fire test. Needless to say the new found control was very welcomed. After about half of a 30 round magazine at the fastest fire rate I could get, I was officially impressed. To remove the furniture you must drive the pin out. Some models will have a one end larger than the other, so be careful. A small punch and hammer will most likely be required. If your hand guard ferrule will not fit all of the way on the upper hand guard you may need to trim the guard a fraction, just make sure to do a little at a time for the ferrules will fit tight.

This picture shows the stock receiver cover replaced with a see through receiver cover for installing optics. I am sure you will enjoy it. The difference makes it even more enjoyable to shoot. It never hurts to have a blade handy.